Calibration Procedures - NCR RealPOS 25 User Manual

3-78
• Do NOT get your hand and other fingers too close to the bezel.

Calibration Procedures

Note:
operating position when AC power is applied to the terminal (45 degrees can be
assumed if this not known). If this was NOT done properly then begin with Step 1.
Otherwise skip to Step 2.
1. Select
In order to achieve an accurate calibration the touch display must in the normal
Start→Programs→Microchip TSHARC Control
Note:
The Calibration program can also be started with the Touch icon at the
bottom of the screen.
LED Diagnostic Indicators
Panel.
27737