NCR RealPOS 25 User Manual page 4

iv
Warning:
is connected to AC power. This can result in system or printer damage.
Warning:
is connected to AC power. This can result in system or printer damage.
Battery Disposal (Switzerland)
Refer to Annex 4.10 of SR814.013 for battery disposal.
IT Power System
This product is suitable for connection to an IT power system with a phase-to-phase
voltage not exceeding 240 V.
Grounding Instructions
In the event of a malfunction or breakdown, grounding provides a path of least
resistance for electric current to reduce the risk of electric shock. This product is
equipped with an electric cord having an equipment-grounding conductor and a
grounding plug. The plug must be plugged into a matching outlet that is properly
installed and grounded in accordance with all local codes and ordinances. Do not
modify the plug provided – if it will not fit the outlet, have the proper outlet installed by
a qualified electrician. Improper connection of the equipment-grounding conductor can
result in a risk of electric shock.
The conductor with insulation having an outer surface that is green with or without
yellow stripes is the equipment-grounding conductor.
If repair or replacement of the electric cord or plug is necessary, do not connect the
equipment-grounding conductor to a live terminal. Check with a qualified electrician or
service personnel if the grounding instructions are not completely understood, or if you
are in doubt as to whether the product is properly grounded.
Use only 3-wire extension cords that have 3-prong grounding plugs and 3-pole
receptacles that accept the product's plug. Repair or replace damaged or worn cords
immediately.
References
• NCR RealPOS 25 Site Preparation Guide (B005-0000-2018)
• NCR RealPOS 25 Hardware Service Manual (B005-0000-2019)
• NCR RealPOS 25 Parts Identification Manual (B005-0000-2020)
DO NOT connect or disconnect the transaction printer while the terminal
DO NOT connect or disconnect any serial peripherals while the terminal