Download
Share
Print this page
  1. Manuals
  2. Brands
  3. NCR Manuals
  4. Touch terminals
  5. RealPOS 2x20
  6. Kit instructions

NCR RealPOS 2x20 Kit Instructions

Customer display integrated on pos stand
Hide thumbs

Advertisement

Quick Links

Download this manual
KIT INSTRUCTIONS
2x20 Customer Display Integrated on POS Stand
7702-K450
Issue A

Advertisement

loading

Related Manuals for NCR RealPOS 2x20

Summary of Contents for NCR RealPOS 2x20

  • Page 1 KIT INSTRUCTIONS 2x20 Customer Display Integrated on POS Stand 7702-K450 Issue A...

  • Page 2: Revision Record

    NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current.
  • Page 3 2x20 Customer Display Integrated on POS Stand This kit contain the components to add an integrated 2x20 customer display on the RealPOS XR7 POS. The display is mounted on the back of the POS Stand. Components...

  • Page 4: Installation Procedures

    2x20 Customer Display Integrated on POS Stand Installation Procedures 1. Pivot the display back. 2. Remove the Upper Stand Cover by pivoting it away from the stand. The cover has a simple snap fit connection at the top.
  • Page 5 2x20 Customer Display Integrated on POS Stand 3. Open the Base Cable Cover (captive thumb screw). 4. Remove the NCR Logo Stand Badge(screw).
  • Page 6 2x20 Customer Display Integrated on POS Stand 5. Feed the USB Cable through the Cable Management Bracket and slide the Cable Overmold into the bracket. 6. Connect the USB Cable to the PCB.
  • Page 7 2x20 Customer Display Integrated on POS Stand 7. Route the excess cable to the right and around the board connector and install the Cable Management Bracket. Insert the tabs of the Cable Management Bracket into the slots in the Rear Cover. Pivot the bracket as shown until it snaps into position.
  • Page 8 2x20 Customer Display Integrated on POS Stand 8. Install the 2x20 Bracket (2 flat-head screws). 9. Route the USB Cable through back of the stand. 10. Install the 2x20 Module onto the stand (3 screws, the middle screw is longer).
  • Page 9 2x20 Customer Display Integrated on POS Stand 11. Route the cable up through the POS Stand. Close and secure the Base Cable Cover. 12. Connect the USB Cable to a +12V USB connector on the terminal. 13. Re-install the Upper Stand Cover.