Table of Contents
Advertisement
INSTALLING THE FAN
SELECT TYPE OF INSTALLATION
HANG DOWN STYLE
1 Slide the canopy on the downrod(Fig.6) Thread the power leads from the fan
through the canopy and downrod. Take extra care not to pull on power wires. Damage
and loose connections could result from any abnormal pressure on these wires. Set
downrod into downrod collar yoke. Route until the holes match. Being careful not to
damage wiring, insert connector pin through the holes (See Fig. 6A. 6B). Secure the
pin by inserting the stop pin through the connector pin.
WARNING: Do not force connector pin through downrod. Use of force could cause
damage to wires inside. Make sure the stop pin is properly engaged to prevent it from
falling out.
2 Tighten downrod setscrew. Some models have a locknut for the setscrew. To insure
the setscrew fully seats against the downrod. It is necessary to back off the locknut
until it contact the setscrew head prior to tightened the setscrew. When setscrew is
tightened against downrod.locknut should then be tightened against connector yoke.
Some models have 2 downrod setscrews. Repeat for both (Fig.7)
Page 6
Advertisement
Table of Contents
