Module Connections - Tektronix KEITHLEY 7703 Instructions For Use Manual

Model 7703 Multiplexer Module Instructions for use with 2750
Connections
The following information describes how to make connections to the switching module and define the channel
designations. A connection log is provided that you can use to record your connections.
Connection and wiring procedures in this document are intended for use by qualified
personnel only, as described by the types of product users in the
8). Do not perform these procedures unless qualified to do so. Failure to recognize and
observe normal safety precautions could result in personal injury or death.

Module connections

Do not exceed the maximum specifications for the 7703 switching module. Refer to the
specifications provided in the datasheet. Failure to recognize and observe normal safety
precautions could result in personal injury or death.
You must install a connector cover on an unused D-sub connector. If the connector is left
open, an electrical shock hazard may be present. Failure to recognize and observe normal
safety precautions could result in personal injury or death.
When you are looking at the rear connectors of the 7703 switching module, the connector on the left is P1017 and
the connector on the right is P1016.
2
Figure 2: Model 7703 Pinouts (P1017 and P1016)
Safety precautions (on page
077182500 July 2023