Assembling The Cabin; Mounting The Feet; Assembling The Barrel Staves; Assembling The Front And Rear Wall - Harvia KAMMI 220 Assembly Instructions Manual

Assembly instructions

2. Assembling the cabin

ATTENTION!
Note the floor plan on Page 10 and illustrations from Page 9 onwards.

2.1. Mounting the feet

Place the impregnated feet on the foundation as shown in the illustration (see
Page 12). Fix them temporarily with two staves.
Make sure that the feet are fitted parallel to each another.
Note the power supply!

2.2. Assembling the barrel staves

Always put the staves together with the round part facing upwards.
Start by placing the lower stave in position (with drain — see page 13).
Lay four staves to the left and four to the right and screw the feet to the staves.
Make sure that there is no visible gap between the staves.

2.3. Assembling the front and rear wall

Connect the individual parts of the front and rear wall as shown (see page 14).
Place the walls in the groove of the staves. Check the vertical alignment with the
spirit level and provisionally fix in place with two staves.
For the lighting, first fit the metal clips on the wooden strip. Fix the wooden strip
in the centre of the back wall, approx. 5 cm above the floor grid. Clamp the LED
strip and drill the cable bushing at the desired location (the power supply unit
may be placed outside the sauna).

2.4. Completing the barrel

Fit the remaining staves. Fix them to the front and back walls using screws, or
use a strap if you would like to avoid screw holes (these will be visible on the
outside when finished).
Closing the barrel: Use whatever is required from the supplied filler set (= stave
in strips).
p. 7/8
EN