Assembling The Cabin; Assembling The Base Frame; Assembling The Floor Substructure; Assembling The Cabin Walls - Harvia SOLIDE COMPACT VISION Assemble Instructions

Installation instructions

4. Assembling the cabin

ATTENTION!
Note the floor plans on Page 10 11 and the figures from Page 1315
onwards.

4.1. Assembling the base frame

Place the impregnated base frame on the foundation as shown on the floor plan
and the foundation illustrations (see Page 10 11).
Glue and screw the base frame at the corners.
Connect the base frame to the concrete foundation at the corners (see 1.3 on
page 4).
Make sure that the base frame is assembled at right angles.
For electric sauna heaters, pay attention to the power supply!

4.2. Assembling the floor substructure

Place the impregnated floor frame in the cabin and screw it to the base frame.

4.3. Assembling the cabin walls

Always put the wall planks together with the tongue facing upwards.
NEVER hit the tongue directly with a hammer!
Start by assembling the block planks on the back wall. Proceed row by row. As
with the base frame, glue and screw the corners together.
Hammer the iron pins into the pre-drilled holes in each row.
Note the position of the ventilation slide in rows 2 and 14 and the block planks with
slots for assembling the exterior door in rows 7/8 and 12/13.

4.4. Assembling the windows

Insert the window frame from the outside and attach it by assembling the door
cover strips from the inside.

4.5. Assembling the door

Place the exterior door in the door opening and attach it by assembling the door
panel from the inside.
p. 13/14
EN