Assembling The Cabin; Mounting The Feet; Assembling The Barrel Staves; Assembling The Front And Rear Wall - Harvia Sentiotec KASKI 240 Panorama Canopy Assembly Instructions Manual

Assembly instructions

2. Assembling the cabin

ATTENTION!
Note the floor plan on Page 10 and illustrations from Page 9 onwards.

2.1. Mounting the feet

Place the impregnated feet on the foundation as shown in the illustration (see
Page 12). Fix them temporarily with two staves.
Make sure that the feet are fitted parallel to each another.
Note the power supply!

2.2. Assembling the barrel staves

Start by placing the lower stave in position (with drain —see page 13).
Always put the staves together with the round part facing upwards.
Lay five staves to the left and five to the right and screw the staves to the feet.
Make sure that there is no visible gap between the staves.

2.3. Assembling the front and rear wall

Connect the individual parts of the front wall as shown (see page 14).
Place the walls in the groove of the staves. Check the vertical alignment with the
spirit level and provisionally fix in place with two staves.
Place the glass element on the back wall and provisionally fix in place with two
staves. Mount the cover strips inside and outside.
ATTANTION - GLASS BREAKAGE!
At the glass element, the screws may ONLY be screwed in flush - screws
that are countersunk can cause glass breakage.
For the lighting, fix the wooden strip in the centre of the back wall, approx. 10 cm
above the floor grid.

2.4. Completing the barrel

Fit the remaining staves. Fix them to the front and back walls using screws.
Closing the barrel: Use whatever is required from the supplied filler set (= stave
in strips).
p. 7/8
EN