Assembling The Cabin; Assembling The Base Frame; Assembling The Cabin Walls; Assembling The Roof Elements - Harvia FENIX SHF1620S Instructions For Installation Manual

Instructions for installation
3.

Assembling the cabin

ATTENTION!
Note the floor plans on pages 8 as well as the illustrations starting on
page 12 (following the last language of the instructions).

3.1. Assembling the base frame

Start with the base frame and screw it to the corners. Move the base frame to
the final position of the sauna.

3.2. Assembling the cabin walls

Note the outside/inside of the wall elements.
Make sure the ventilation element is correctly positioned. It must be
placed diagonally opposite the heater.
Start assembling the wall elements with the ventilation element and screw it to
the corner post (G, H). The other wall elements are connected by tongue and
groove and are fixed by mounting the roof frame. Check the right angles (see
tip on page 4).
Mount the multiclips to the front sides of the wall elements and to the corner posts
(A, B). Make sure that the multiclips are correctly aligned – the corner posts are
connected to the wall elements from top to bottom.
Fit the ventilation slider.

3.3. Assembling the roof elements

Insert the roof elements and screw them to the cabin walls. Note the cable outlet.

3.4. Assembling the benches

Mount the bench support slats on the side wall elements. Connect the angle
bench to the sauna bench using M10 x 120 screws. Screw the adjustable feet
into the bench foot. Fix the bench foot to the angled bench by tightening up the
lock and screw the bench foot to the side wall.
Assemble the bench screen and the backrest.
p. 9/10
EN