Mounting The Door; Installing Interior Fittings; Installing Accessories; Covering The Roof - Harvia KAMMI 220 Assembly Instructions Manual

Assembly instructions p. 8/8
Fit the tensioning straps.
Note that the tension rods are placed in the lower half of the barrel sauna.
Before tensioning the metal bands, remove the screws from the staves. Tighten
the metal bands so that there is no visible gap between the staves. This must
be checked regularly and retightened if necessary.

2.5. Mounting the door

Place the door frame in the opening from the outside. Note that the door opens
outwards — the door can be attached on the left or on the right.
Fix the door from the inside with the cover slats.
The door handles are screwed from the inside.
Fit the weatherboard (drip edge).

2.6. Installing interior fittings

Place the floor grid so that it is level.
Fit the bench support slats at a height of approx. 45 cm to the floor grid.
Install the benches.
Fix the backrests approx. 20 cm above the bench.

2.7. Installing accessories

Fit the ventilation panel on the inside.
Assemble the protection grille.
Fit the insect screen on the outside.

2.8. Covering the roof

Install the triangular strips (drip edge) at a height of approx. 110 cm.
Start attaching the bitumen shingles on the triangular strip with the top of shingle
sheets facing down. Now lay the other shingle sheets overlapping and evenly
offset. You can make the top ridge row from sections. These are laid overlapping
in a scale-like manner. Pay attention to the prevailing wind direction.