S100 / OPMI® pico
8
LED illumination unit
8.1
Changing the power supply board
1) If a camera control unit is installed, loosen four
screws (1) and install the CCU again with two
screws like shown on the picture.
2) Pull flap (2) and remove the case lid (3).
3) Disconnect the CCU cable from the PCB.
4) Loosen two screws M 3 x 6 ISO 10644 and slide
off mounting bracket.
5) Unscrew four screws M 4 x 40 ISO 14583 (4)
and remove the side cover along with the CCU.
SM-30-0030-A02
Version 07, 2015-12-03
Fig. 41: Change the power supply board
2
3
Fig. 42: Disconnect the CCU cable
Fig. 43: Remove the side cover
Confidential and Proprietary
23 / 27
1
4
Service Instructions
Order No. -