Built-In Reset Switch; Audio Alarm - Chamberlain ELITE Series Owner's Manual

The alarm could be tripped when one of the following happens twice consecutively,
Press the built-in reset switch to shut off alarm and reset operator (see above).
The operator arm or gate
is incorrectly installed.
An externally wired photoelectric sensor has been
triggered twice (photoelectric sensor blocked).
The gate is moving and a car pushes the
gate.
B U I L T - I N R E S E T S W I T C H
When the gate operator's audio alarm (see below) has been tripped, the reset switch must be
pushed for the operator to function again.
The reset switch will shut off an activated audio alarm and reset the operator to function again.
If the audio alarm goes off, always check the gate area for:
Pressing the reset switch will stop a moving gate during a
normal open/close cycle, like a stop button. The operator
does NOT
A U D I O A L A R M
then the alarm will sound for 5 minutes or until the reset switch is pressed!
Horizontal Level
Incorrect
The gate is TOO heavy.
Gate hinges are too tight or broken and
the gate is not moving freely.
• Obstructions in the gate path.
• Damage to the gate and/or gate operator.
need to be reset after doing this.
35
Vertical
Level
Incorrect
A foreign object is on the gate frame while
the gate is moving.
The gate hits the driveway, curb or other, and
gets stuck or bent in an awkward position.