Dc2000 Back-Up Connections - Chamberlain ELITE Series Owner's Manual

F A C T O R Y I N S T A L L E D D C 2 0 0 0 ™ C O N N E C T I O N
Reset button and interlock wires, Do Not Remove.
110Vac Power Failure
Manual Mode Push and
Gate automatically opens.
Auto Mode
NOTE: All devices wired to the DC2000™ MUST be dedicated to it alone. Normal operation will be controlled by separate devices wired
to the OmniControl™ board and surge suppressor.
Example: If the DC2000 is "automatically opening" the gate due to a power failure (auto mode), any manual command such as
"One-Button", "Three Push Button", "Key Switch", "Photoelectric Sensor" or "Edge Sensor" will cancel the automatic mode of the
DC2000™. After such cancellation, the DC2000™ will continue to operate in "manual mode" until 110Vac power is restored.
D C 2 0 0 0 ™ 1 2 V d c R a d i o R e c e i v e r ( N o t P r o v i d e d )
The DC2000™ needs a separate 12Vdc radio receiver to give remote commands to the operator during a power failure.
Socket
Hold to operate gate.
to Constant (C)
+12Vdc
D C 2 0 0 0 ™ S t a r t u p
Plug in the 12 pin plug into the DC2000™ control unit. Make sure
the "System ON" and
led comes on, the battery needs to charge before it can be used.
Make sure "Gate Direction" setting on DC2000™ is set the same as
the OmniControl™ board setting. See Adjustments.
Adjust "Reverse Sensor" setting. See Adjusting Reverse Sensor(s).
110Vac Power On,
OmniControl™ Board Malfunction
Turn the 110Vac power off then push and
Turn the 110Vac power off then gate opens automatically.
Jumper P2:
Jumper P3:
to 12 Volt
21
"Charge OK" LEDs are lit. If the
Hold to operate gate.
NOTE: Refer to page 29
and 30 for programming
radio receiver.
"Battery Low"