Operations; Adjustments; Initial Setup - Schwinn 570U Assembly Manual / Owner's Manual

Hide thumbs Also See for 570U:
Table of Contents

Advertisement

OPERATIONS

What to Wear
How Often Should You Exercise
Consult a physician before you start an exercise program. Stop exercising if you feel pain or tightness in
your chest, become short of breath, or feel faint. Contact your doctor before you use the machine again.
Use the values calculated or measured by the machine's computer for reference purposes only. The heart
rate displayed on the console is an approximation and should be used for reference only.
• 3 times a week for 30 minutes each day.
• Schedule workouts in advance and try to follow the schedule.
Seat Adjustment
injury.
1. With a Pedal in the forward position, center the ball of your foot over the center of it. Your leg
should be bent slightly at the knee.
2. If your leg is too straight or your foot cannot touch the Pedal, move the seat down on the upright
bike. If your leg is bent too much, move the seat up.
!
Loosen and pull the adjustment knob on the seat tube. Adjust the seat to the desired height.
Release the adjustment knob to engage the locking pin. Be sure that the pin is fully engaged and
fully tighten the knob.
Do not set the Seat Post position higher than the stop mark (STOP) on the tube.
!
To move the seat closer to, or away from the console, loosen the seat slider adjustment knob. Slide
the seat forward or rearward to the desired position and tighten the knob.
Foot Position / Pedal Strap Adjustment
Foot pedals with straps provide secure footing to the exercise bike.
1. Put the ball of each foot on the Pedals.
2. Rotate the Pedals until one can be reached.
3. Fasten the strap over the shoe.
4. Repeat for the other foot.
Power-Up / Idle Mode
The Console will enter
pushed, or if it receives a signal from the RPM sensor as a result of pedaling the machine.
while in Sleep Mode.
Note: The Console does not have an On/Off switch.

Initial Setup

2.
Push OK to set.
22
/ Idle Mode if it is plugged into a power source, any button is

Advertisement

Table of Contents
loading

Table of Contents