Advertisement
Available languages
Available languages
V1.0
5.
Make certain the power source conforms to requirements of your
equipment (see Specifications).
6.
When wiring an electrically driven tool, follow all electrical and safety
codes, as well as the most recent Canadian Electrical Code (CE) and
Canadian Centre for Occupational Health and Safety (CCOHS).
7.
This tool is only for use on 120 V (single phase) and is equipped with
a three-prong grounded power supply cord and plug. Check with a
qualified electrician if you are in doubt as to whether the outlet is
properly grounded. If the tool should electronically malfunction or
break down, grounding provides a low resistance path to carry
electricity away from the user.
7.1 Never remove the grounding prong or modify the plug in any
way, as this will render the tool unsafe.
7.2 Do not use any adapter plugs.
8.
A separate electrical circuit should be used for this tool.
8.1 This circuit should not be less than #12 wire and should be
protected with a 20A time lag fuse.
9.
If using an extension cord, select one with a 3-wire cord with a 3-
prong grounding plug.
10. All extension cords should be heavy enough to carry the current of
the machine. An undersized cord will cause a drop in voltage,
resulting in loss of power and overheating.
CORD LENGTH
>25
25 to 50
50 to 100
100 to 150
WARNING! All wiring should be performed by a
qualified electrician.
Visit www.princessauto.com for more information
8 in. Variable-Speed Bench Grinder
CORD GAUGE
18 AWG
16 AWG
16 AWG
14 AWG
9040379
9
Advertisement
