pro.point 9040379 Manual page 17

V1.0
To replace or change one of the tool's grinding
wheels, accomplish the following (Fig. 12, 13 and
14).
1. Remove the screws (#54) securing the outer
face of the wheel guard to the tool frame.
2. Remove the wheel guard (H).
3. Place on hand on the wheel to prevent it from
moving while using a suitable wrench to
loosen the arbor nut (Fig. 13-1).
4. Remove the arbor nut, wheel flange (#56)
and old grinding wheel (B).
1. Use a brush or compressed air to remove
any dust or debris from air passages and
other areas of the tool. Do not use hands.
2. All plastic parts should be cleaned regularly
with a soft, damp cloth. Never use solvents
to clean plastic parts.
Inspect and lubricate the tool when required.
Only use light oil to lubricate the tool. Other
lubricants may not be suitable and could damage the tool or
cause a malfunction during use.
When not in use for an extended period, apply a thin coat of lubricant to
the steel parts to avoid rust. Remove the lubricant before using the tool
again.
NOTICE! NEVER use a penetrating oil to lubricate
the tool. Penetrating oil may act as a solvent
that will break down the grease and cause the tool
to seize up.
Visit www.princessauto.com for more information
8 in. Variable-Speed Bench Grinder 9040379
Fig. 12
Fig. 13
Fig. 14
17