pro.point 9040379 Manual page 13

V1.0
4. Adjust the position of the tool rest support so that the tool rest is
approximately 1/8 in. from the grinding wheel (B).
5. Repeat steps 1 through 4 for the second tool
rest.
This tool comes with convenient on-board tool
storage for the provided dressing tool. It is located
at the rear base of the tool. (Fig. 3-1).
To confirm the tightness of the arbor nuts, which is
recommended before proceeding with any
operation, accomplish the following (Fig. 4).
1. Remove the screws (#54) securing the outer
face of the wheel guard to the tool frame.
2. Remove the wheel guard (H).
3. Place on hand on the wheel to prevent it
from moving while using a suitable wrench
to tighten the arbor nut (Fig. 5-1).
4. Repeat steps 1 through 3 for arbor not on
the alternate side.
NOTICE! The arbor nut on the
right side of the machine
tightens clockwise, while the
arbor nut on the left side of the
machine tightens counterclockwise.
NOTICE! As you use the tool, the force and
direction of the wheel will cause the arbor nut to
tighten automatically. It is recommended, however,
that you check the tightness of the arbor nut
before each operation.
Visit www.princessauto.com for more information
8 in. Variable-Speed Bench Grinder 9040379
Fig. 3
Fig. 4
Fig. 5
13