pro.point 9040379 Manual page 12

9040379
Numbered references in parenthesis (#1) refer to the included Parts List.
Letter references in parenthesis (A) refer to the included Identification Key.
Dashed numbers in parenthesis (Fig. 1-1) refer to a specific point in an
illustration or image.
To attach the spark shields, accomplish the
following (Fig. 1).
1. Fit two M5 x 10 mm hex screws with an M5
lock washer and flat washer.
2. Use the assembled hex screws and washers to
secure the spark shield (F) to the wheel guard
(H). The spark shield should be approximately
1/8 in. from the grinding wheel.
3. Repeat steps 1 and 2 for the second spark shield.
To attach the grinding shields (G), accomplish the following.
1. Insert one of the M6 x 16 mm carriage bolts through the outermost
hole in the spark shield.
2. Secure using one of the M6 flat washers, one lock washer and a
threaded thumb knob.
3. Repeat steps 1 and 2 for the second grinding shield.
To attach the tool rests (E), accomplish the following
(Fig. 2).
1. Remove the tool rest lock knob (#46), star washer
and washer from the carriage bolt on the lower
portion of the wheel guard.
2. Using the carriage bolt, star washer, washer and
knob, attach the work rest bracket to the inside
of the wheel guard (H).
3. Attach the tool rest (E) to the tool rest support
using the lock nut (#49).
12
8 in. Variable-Speed Bench Grinder
For technical questions call 1-800-665-8685
V1.0
Fig. 1
Fig. 2