pro.point 9040379 Manual page 7

V1.0
3. Do not cover the air vents. Proper cooling is necessary prevent
damage to the tool's motor.
4. Avoid unintentional starts. Ensure the switch is off when connecting
to the power source.
5. Disconnect the power source before installing or servicing the tool.
6. Remove adjusting keys and wrenches before using the tool. The tool
may eject an attached wrench or a key and cause an injury to you or a
bystander.
7. Never point the tool towards yourself. It could inflict an injury.
8. Never force the tool. Excessive pressure could break the tool,
resulting in damage to your workpiece or serious personal injury.
Excessive pressure is the cause if your tool runs smoothly under no
load, but roughly under load.
9. Keep hands and fingers away from the work area. Any part of the body
contacting the tool's working parts could result in an injury.
10. Only use accessories that are specifically designed for use with the
tool. Ensure the accessory is tightly installed.
11. Only use an accessory that exceeds the Speed Rating (see
Specifications).
12. Before using the tool on a workpiece, test the tool by running it at the
highest no-load speed for at least 60 seconds in a safe position. Stop
immediately if there is any abnormal vibration or wobbling that could
indicate poor installation of the grinding wheel. Check the tool to
determine the cause.
12.1 Do not allow the tool to run without load for an extended period
of time, as this will shorten its life.
13. Never touch the tool accessory or workpiece during or immediately after
use. They may be hot and could inflict a burn injury.
14. Do not touch an operating motor. Motors can operate at high
temperatures and can cause a burn injury.
15. Take work breaks to prevent the tool's motor from overheating
and/or overloading. Refer to the welding unit's duty cycle in
Specifications. Refer to the plasma cutting machine's duty cycle in
Specifications.
Visit www.princessauto.com for more information
8 in. Variable-Speed Bench Grinder 9040379
7