Advertisement
Available languages
Available languages
V1.0
Warning! To reduce the risk of fire, use a 40 watt
or smaller, 120 volt, reflector track type light
bulb (not supplied). A standard household light
bulb should not be used. The reflector track type
light bulb should not extend
below the lampshade.
Whenever this tool is not in use, the on/off
switch should be placed in the OFF
position. For longer periods of inactivity or
for any maintenance work, always
disconnect the tool from its power source.
To lock the tool, remove the switch (#10) by pulling it straight
outwards (Fig. 10-1).
The tool cannot be restarted until the switch is reinserted.
1.
Maintain the tool with care. A tool in good condition is efficient,
easier to control and will have fewer problems.
2.
Inspect the tool fittings, alignment, hoses and power supply cord
periodically. Have damaged or worn components repaired or replaced by
an authorized technician. Only use identical replacement parts when
servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Only use accessories intended for use with this tool.
5.
Keep the tool clean, dry and free from oil/grease at all times.
6.
Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
7.
Always switch the tool off and disconnect from the power source
before performing any inspections or maintenance.
8.
If inspecting or maintaining safety guards, remember to always
replace immediately upon completion.
9.
Regularly check the tightness of all hardware.
Visit www.princessauto.com for more information
8 in. Variable-Speed Bench Grinder
9040379
Fig. 10
15
Advertisement
