Table of Contents
Advertisement
18
Inspection Route
• Delete empty inspection points: This setting defines if all empty inspection points (no
image and no status) will be removed from the inspection route file when the operator
locks an inspection.
18.5 Creating an inspection route
The inspection route is defined by an XML file. The inspection route XML file specifies
the route structure, consisting of multiple levels of nodes (sites/assets) and inspection
points.
The inspection route file also defines the available statuses and the configuration of the
camera behavior.
The inspection route file can be created using one of the following methods:
• The FLIR Thermal Studio application.
• Your own solution. The FLIR Thermal SDK can be used to build your own export/im-
port software or to interface your existing asset management system.
• Create a file in the camera.
• Manually edit an XML file.
18.5.1 Creating an inspection route in the camera
1. Make sure that there is no inspection route XML file on the memory card.
2. Select
(Settings) > Save options & storage > Inspection route > Getting started >
Create an empty Inspection route.
This places a basic XML file on the memory card.
3. In live mode, tap the current point indicator. This displays a drop-down menu.
4. Tap Inspection list. This displays a list with a node placeholder.
5. Tap Edit to enter edit mode.
6. In edit mode, use the following buttons to build the inspection route:
• Tap
to add a new item below the selected one. You can select the name of the
new item and select if the new item is a node or an inspection point.
• Tap
to delete the selected item and all of its dependents.
• Tap
to add comments to the node. These comments will apply to all of its
dependents.
7. Tap Done to exit edit mode.
8. To make changes to the camera behavior configuration, see section 18.4
Configuration.
9. When the inspection route is completed, make sure to copy the XML file on the mem-
ory card to a computer for future use. When you start an inspection in the camera,
the inspection data will be written to the XML file on the memory card.
18.5.2 Manually editing an XML file
An example or empty XML file can be created on the memory card in the camera. This
file can be used as a basis when manually editing an XML file.
1. Make sure that there is no inspection route XML file on the memory card.
2. Select
(Settings) > Save options & storage > Inspection route > Getting started.
#T810587; r. AD/90967/90989; en-US
103
Advertisement
Table of Contents
