Log Installation - Hargrove HARETHC24N2C Installation And Operation Manual

Vent free gas logs

Hide thumbs

Table Of Contents

Table of Contents

HERITAGE CHAR (HCV) LOG DIAGRAM

18" - 5302GOVF

Fig. 1

24" - 5304GOVF

30" - 5306GOVF

18" - 5320GOVF

24" & 30"- 5322GOVF

FAILURE TO POSITION

LOGS PROPERLY MAY

RESULT IN PROPERTY

DAMAGE OR PERSONAL

INJURY!

Step 1 – Identify each of the 9 logs in the set by comparing them to the log picture above. (Fig 1)

Step 2 – Identify the Back Log in the log box. Place the Back log on the grate with the finished area facing forward. (Fig 1)

Step 3 –- Install the Front Logs by placing the notches on the bottom of the front logs on the corresponding grate

tines. (Fig 1)

Step 4 - We will install the top logs from left to right, install the 5312 by placing the flat side of the log on the notches on

the top of the back and front logs. (Fig 1 & 2)

Step 5 – Install the 5307 by placing the flat end on the notch of the 5312 and the notch on the front left log. (Fig 1 & 2)

Step 6 – Install the 5310 (y-shaped) by placing the flat side of the log on the notches on the top of the back log and front

left log (Fig 1 & 2)

Step 7 – Install the 5309 by placing the flat side on the notch of the 5310 and the notch on the front right log. (Fig 1 & 2)

Step 8 - Install the 5314 by placing the flat side in the notches on the top of the back log and the front right log (Fig 1 & 2)

Step 9 – Install the 5311 by placing the flat side in the notch of the back log and the front right log. (Fig 1 & 2)

Step 10 – Assure that all of the logs have at least a 1" clearance around the burner ports of the Back Burner (Fig 2).

Step 11 – Once the set is completely set up, observe the operation of the set. The back flame should not be coming in

contact with any logs. The front flame should cause a glowing effect on the ember material. (Fig 3).

Fig. 2