Table of Contents
Advertisement
WARNING:
ANY MODIFICATION TO THIS UNVENTED GAS HEATER OR ITS CONTROLS CAN BE
DANGEROUS. IMPROPER INSTALLATION OR USE OF THE HEATER CAN CAUSE SERIOUS
INJURY OR DEATH FROM FIRE, BURNS, EXPLOSION OR CARBON MONOXIDE POISONING.
BACK
VIEW
Manual
Valve
Burner
Assembly
BACK
VIEW
Variable
Valve
Burner
Assembly
BACK
VIEW
Millivolt
Valve
Burner
Assembly
IMPORTANT STEPS TO FOLLOW WHEN MAKING THE GAS LINE CONNECTION
1. Consult your gas supplier for proper gas pipe sizing. Normally up to 50' of ½" inside diameter
(ID) gas pipe will supply adequate volume for all vent free units.
2. The incoming gas line may be routed into the fireplace either from the left or right side.
3. Include a manual shutoff valve in the gas supply line so the appliance may be disconnected for
servicing.
4. Center the burner system from side to side in the firebox. In a vented firebox, if the damper is
used, the burner assembly should be located directly under the damper.
5. Use the 3/8" flex connector (provided in the accessory kit) to connect the gas supply line to the
regulator on the burner assembly.
6. Always use an external regulator for all L.P. appliances to reduce the supply tank pressure to a
maximum of 13" W.C. This is in addition to the regulator fitted to the heater.
7. Test all connections after turning gas supply on for leaks using a soap and water solution. DO
NOT USE AN OPEN FLAME FOR LEAK TESTING.
8. It is most convenient to light the pilot and check the operation of the main burner with the logs
not in place. After carefully checking the gas supply line for leaks and correcting any found, refer
to the "LIGHTING INSTRUCTIONS" section to test the burner assembly.
WARNING: DO NOT USE A BLOWER INSERT, HEAT EXCHANGER INSERT
OR OTHER ACCESSORY NOT APPROVED FOR USE WITH THIS HEATER.
GAS CONNECTION
FLEX
CONNECTOR
SHUT OFF
VALVE
½" BLACK
PIPE
GAS
SUPPLY
LINE
DRIP
LEG
7
Advertisement
Table of Contents
