Table of Contents
Advertisement
5) Use dental floss to secure the connection
so they cannot become unplugged.
6) Secure the servo to the aileron hatch using
Phillips screwdriver and the screws provided
with the servo.
7) Apply 1-2 drops of thin C/A to each of the
mounting tabs. Allow the C/A to cure without
using accelerator.
8) Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out. When
you have pulled the servo lead out, remove the
masking tape and the servo lead from the
thread.
9) Set the aileron hatch in place and use a
Phillips screw driver to install it with four wood
screws.
17
Advertisement
Table of Contents
