Bluetooth Connection - PDMOVIE LIVE AIR 3 SMART Product User Manual

1.When installing, it is
recommended to
place the LiDAR as
close to the lens axis
as possible for
optimal results
*Autofocus is compatible with most regular cinema lenses on the market, but not
currently compatible with infinite focus lenses or macro lenses with non-linear
progressive zoom.
*If the lens being used does not have a 0.8mod focus gear, an additional focus ring
needs to be installed. After installation, the motor gear and focus ring gear need to
be tightened to enable the motor to drive the lens properly.
2.Turn On The Bluetooth Controller And Motor
Press the ON/OFF button on the Bluetooth controller for three seconds until the indicator
light powers on. The motor will turn on automatically when the battery is inserted.

3.Bluetooth Connection

The controller and motor are paired at the factory. Turn on the controller and the motor at
the same time, and the Bluetooth will be paired automatically (if the indicator lights at
both ends continue to flash rapidly, it means pairing is in progress). After successful
pairing, the controller indicator light is always on, and the motor indicator light shows the
flashing frequency corresponding to the current speed gear of the motor.(if pairing with
other controllers /motors: the Bluetooth of the controller and the motor needs to be reset,
see Table 3-4 and Table 2-6)
*1.The recommended control distance of the controller within 100 meters,
although the actual control distance can be affected by environmental factors.
*2. In an environment with strong signal interference, The motor and controller
may lose connection. We recommend to shorten the operating distance until
the controller and the motor are connected again.
2.The installation
position of the LiDAR
can be chosen based on
the emphasis of the
composition of the scene
Plug in the
Press the ON/OFF button
battery.
28°
3.The field of view of
the LiDAR is 28
degrees, so when
using it, be careful not
to obstruct it
Light
Searching
Bluetooth
Blinking fast
4
Move closer
Move
further
4.When the front end of
the lens is wide, the
position of the LiDAR
should be adjusted
appropriately to avoid
obstruction.
Controller light
Connect Not blinking
Successful
Motor light
Blinking 1/2/3
times regularly