Table of Contents
Advertisement
-Unless you encounter force majeure factors such as battery damage and drastically
reduced battery life, it is not recommended to replace the controller battery frequently.
-When replacing the battery, Please check the electrode direction when replacing the
battery to avoid incorrect installation of the battery.
-To replace the battery of the motor, please push the battery
to the right side first, then pull it out. (Refer to the direction
indicated by the arrow icon on the motor.) If the battery is
difficult to take out due to slipperiness, please use the
BATTERY STICKER to help remove the battery.
Notice
1. Emergency stop calibration: The motor skips teeth during the automatic calibration process,
resulting in the phenomenon of non-stop rotation. Just click the motor button to terminate the automatic
calibration immediately;
2. When the motor is not calibrated, it cannot be used. When the damping of individual lenses is too
heavy or not smooth, and the motor cannot complete the automatic calibration, the manual calibration
lens travel function can be used
3. The controller defaults to FOCUS mode. If it is switched to ZOOM mode, it will be divided equally
based on the rotation of the wheel by 300 degrees, and the middle 10 degrees will be the stationary
position. Turn left to move forward, turn right to move backward. The propulsion speed is linearly
adjusted according to the angle of rotation.
Slow
Fast
4. When the rotating stroke of the motor does not match the calibrated stroke, please check whether
the indicator light of the Bluetooth controller is blue and the color of the current battery flashes
alternately. If the above state occurs, it means that the controller has set the point A-B stroke Limit, you
need to briefly press the controller button to start the A-B automatic operation, and then press it again
to cancel the automatic operation and cancel the A-B point travel limit. (*A-B point command logic: click
the 1st time = set point A; click the 2nd time = set point B; click the 3rd time = start the automatic
running of the A-B point cycle; click the 4th time = stop the automatic operation Run and cancel the A-B
point limit.)
5. The PD-BTMP-S Bluetooth motor supports adjusting the three-speed response speed. Short press
the motor button 5 times to switch the three-speed response speed cyclically. The speed gears are
slow, medium, and fast. After switching the motor speed , the motor indicator will cycle to display the
corresponding flashing frequency. Fast = 3 flashes; medium = 2 flashes; slow = 1 flash.
6. Regarding battery maintenance: When the product is not used for a long time, it is recommended to
check the power of the device every other month to ensure that the battery has sufficient power; when
the device is in a low or no power state for a long time, the battery capacity will become smaller. If the
battery is swollen, do not continue to use the battery to avoid the battery being stuck in the battery
compartment and difficult to remove.
Stop
Slow
Fast
In ZOOM mode, there are three
speed control gears.
Short press the controller button
for 5 times to change speed.
12
Push the battery
to the right first
Then pull the battery
Advertisement
Table of Contents
