Table of Contents
Advertisement
Table 1 Motor Automatic Focus Setting
Number of press on the buttons
①
Long press for 3 seconds
②
Short press a times and then long press for 3 seconds
Short press to mark the first point
③
Short press to mark the second point
Short press to mark the third point
④
Short press a time after AF setup
⑤
Short press twice
After completing the three AF setup steps. Test the autofocus by checking the accuracy of the
③
focus from 4 meters to the closest focus distance. If it is accurate, the AF setup is complete. If it
is not accurate, check if there are any errors in the AF setup steps and try again according to the
steps.
Table 2 Motor Button Command
Number of press on the buttons
①
Long press for 3 seconds
②
Short press a times
③
Short press 4 times
④
Short press 5 times
⑤
Short press 7 times
Short press 3 times and then
⑥
long press for 3 seconds
③
To clear the calibrated travel distance, there is no need to restart the motor. Simply press the button
4 times briefly to delete the travel distance. To restore the travel distance after power failure, such
as when the motor battery is replaced and restarted, simply press the button 4 times briefly to
restore the previously calibrated travel distance.
When the motor speed is switched, the motor indicator will cycle to display the corresponding
④
flashing frequency. Fast = 3 flashes; medium = 2 flashes; slow = 1 flash.
AUTOMATIC CALIBRATION
AF SETTING CALIBRATION MODE
MARKING CAN ONLY BE DONE AFTER
IN-FOCUS WITH A REFERENCE
OBJECT IN AF SETTING MODE
PAUSE/RESUME AUTOFOCUS
SWITCH LENS CHANNEL
AUTO CALIBRATION
EMERGENCY STOP AUTO CALIBRATION
RESTORE THE LENS STROKE WHEN POWER
OFF / REMOVE THE LENS STROKE
SWITCH MOTOR SPEED(FAST·MEDIUM·SLOW)
PULSE FREQUENCY（3/2/1 TIMES）
SWITCH MOTOR ROTATE DIRECTION
BLUETOOTH PAIRING
8
OF LENS STROKE
Advertisement
Table of Contents
