Table of Contents
Advertisement
4.Calibration
(1) Press the ON/OFF button of the Bluetooth controller once, then press it again
and hold until the motor rotates.
(2)
Press and hold the button on the bottom of the motor for three seconds until
the motor rotates.
(1) Press the button once, then press it
again for three seconds.（see Table 3-3）
Bluetooth
controller
(3) Manually calibration:
A. When the motor gear and the lens gear are completely connected, trun on
the motor and turn the lens to the starting point and hold for 0.5 seconds.
B. Then turn the lens ring to the end and hold for 0.5 seconds.
C. Finally, turn the lens ring slightly to the middle, Calibrate done.
(It is recommend that you use manual calibration when using a lens
with out hard stop)
(1) Turn the lens ring to
the starting point and
hold for 0.5 seconds.
*After completing steps 1 to 4, you can use the controller to drive
the motor. For more command settings, see Table 2 and Table 3.
Autofocus setup Steps
1.Things to know before AF setup
1
Please print the focus card on regular A3 or A4 paper and paste it on a
non-reflective wall.
(2) Press the button for three
seconds.（see Table 2-1）
5
Motor
(2) Turn the lens ring to the
ending point and hold for 0.5
seconds, then turn the lens
ring slightly toward the center.
Advertisement
Table of Contents
