Table of Contents
Advertisement
O p e r a t i o n
Fig. 23
Set the fuel valve (Fig. 23) to "STOP" position
l
(closed).
Fig. 24
Pull the rope by the starter handle (Fig. 24) un-
l
til resistance can be felt.
Let the starter handle run back to initial posi-
l
tion.
i
Note
This procedure protects against moisture deposits
inside the engine.
2 8
4.6 Changing the tamper foot
plate
Fig. 25
After changing the tamper foot plate (Fig. 25)
l
tighten the 4 fastening screws with a tightening
torque of 60 to 70 Nm (44 to 52 ft.lbs).
i
Note
When changing the tamper foot to a different width
use only genuine BOMAG parts.
After changing the tamper foot check the engine
speed, adjust it if necessary.
B O M A G
BT 60 / BT 65
Advertisement
Table of Contents
