Table of Contents
Advertisement
4.7 Loading/transport
Danger
!
Danger of accident!
Always shut the engine down to transport the
tamper or to lay it on its side.
Make sure that persons are not endangered by
the machine tipping or sliding off.
Lash the machine down, so that it is secured
against rolling, sliding and turning over.
For lifting the machine attach the lifting gear
only to the cross strut of the steering handle.
The machine should not swing about when be-
ing lifted.
Do not stand or step under loads being lifted.
Use only safe lifting gear of sufficient load
bearing capacity Minimum lifting capacity of
lifting gear: see operating weight in chapter
"Technical Data".
Check all lifting and lashing points for damage
before lifting or lashing down the machine.
Fig. 26
Always shut the engine down to transport the
l
tamper or to lay it on its side.
Lay down the tamper (Fig. 26) to transport it on
l
the rollers.
BT 60 / BT 65
Fig. 27
For loading the machine attach the lifting gear
l
only to the cross strut of the steering handle
(Fig. 27).
541010
B O M A G
O p e r a t i o n
541011
2 9
Advertisement
Table of Contents
