Table of Contents
Advertisement
To remove or replace the glass (D):
6.
Remove the door from its hinges and lay it on
a soft, flat surface.
7.
Remove the screws (A), the glass retainers
(B), and the metal frames (C).
8.
Remove the glass (D). If it is damaged install
a new one in place. The replacement glass
must have a gasket all around (see procedure
below).
9.
Reinstall the glass, being careful to centre the
glass in the door and not to over-tightening
the retaining screw.
The two main causes of broken door glass are uneven placement in the door and over-
tightening the retaining screws.
4.1.6
Glass Gasket Replacement
The glass gasket is flat, adhesive-backed, woven fibreglass. The gasket must be centred on the
edge of the glass.
1.
Follow the steps of the previous section to remove the glass.
2.
Remove the old gasket and clean the glass thoroughly.
3.
Peel back a section of the paper covering the adhesive and place
the gasket on a table with the adhesive side up.
4.
Stick the end of the gasket to the middle of one edge, then press
the edge of the glass down onto the gasket, taking care that it is
perfectly centred on the gasket.
5.
Peel off more of the backing and rotate the glass. The gasket must
not be stretched during installation.
6.
Cut the gasket to the required length.
7.
Pinch the gasket onto the glass in a U shape, all around the glass.
By following these instructions, the edge clearances are maintain.
Page 20
C
D
E
Figure 22 : Replacing the glass
Product Specification Manual - Solution 1.7-I
B
A
Advertisement
Table of Contents
