Advertisement
3. If using an optional light fitting, ensure the glass is properly fitted and / or the screws
holding the glass are firm.
4. If a solid state speed control has been fitted this can cause noises in the motor do not use
these control.
5. Allow at least 24 hours for the fan to settle, as many noise will go away. Each blade set is
weighed and is a complete set, if installing more than one fan do not mix the blades as this
can cause wobble.
The fan oscillates
1. Check the blades are securely fastened to the holders.
2. Check the blade holders are tight on the motor
3. Ensure the mounting bracket is properly screws to the ceiling.
4. Interchange opposite blade sets if need be
In general , wobble is caused by the blade not cutting the air at the same point measure
down from the ceiling and make sure each blade is at the same height to the ceiling, if they
are not a small adjustment can be made by hand by slightly bending the blade and bracket. If
a major adjustment is needed insert a washer (not provided)
Advertisement
