Performing Several Commands In Sequence Automatically (Macro Play) - Sony STR-DG900 Operating Instructions Manual

Performing several
commands in sequence
automatically
(Macro Play)
The Macro Play function lets you link several
IR codes in a sequential order as a single
command. The remote provides 2 macro lists
(MACRO 1 and MACRO 2). You can specify
up to 20 IR codes for each macro list.
Setting the sequence of IR
codes
1
Press MACRO 1 (or MACRO 2)
for 1 second while holding
down RM SET UP.
The RM SET UP indicator flashes.
The remote initial setting is VIDEO1, so
VIDEO1 indicator is light up.
2
If you want to change to
another input, press the input
button you want for 1 second.
The input button indicator flashes twice
slowly and lights up.
3
Press the appropriate button on
the remote control to be
programmed.
The input button indicator flashes twice
slowly.
To delay the output of an IR code
• Press MACRO 1 (DVD TOP MENU)
when the macro setting in MACRO 1.
• Press MACRO 2 (DVD MENU) when
the macro setting is MACRO 2.
1 second delay is programmed at this
program step.
The input button lights up twice slowly.
4
Repeat steps 1 through 3 to
program up to 20 IR codes.
Tip
If programming is unsuccessful, check if the
indicator does not light up in step 1, the batteries are
weak.
Replace both batteries.
To exit programming
Press RM SET UP during any step.
To start macro play
Press TV button (TV button will
lights up), then press MACRO 1 or
MACRO 2.
Note
If the Macro Play function does not work properly,
program a delay between each operation.
See "To delay the output of an IR code" in step 3.
93
US