Table of Contents
Advertisement
EN
When You Are Finished
1. Power OFF the receiver.
2. Power OFF the transmitter.
3. Disconnect and remove the battery from the boat.
TIP: Always remove the canopy before storage or moisture
may allow mold and mildew to grow in the boat.
4. Drain water from inside the hull using the drain plug.
5. Fully dry the inside and outside of the boat, including the water
cooling lines and motor cooling block. Carefully dry all battery,
motor and receiver connectors by removing one at a time and
reinstalling.
6. Remove the hatch before storing your boat.
7. Repair any damage or wear to the boat.
8. Lubricate the flex shaft using Pro Boat ® Marine Grease
(DYNE4200 or DYNE4201).
9. Note the lessons learned from the trimming of your boat, including
water and wind conditions.
10. Replace the rudder cover to protect the rudder's sharp points.
NOTICE: When you are finished boating, never leave the boat in
direct sunlight or in a hot, enclosed area such as a car. Doing so
can damage the boat.
NOTICE: Using a larger propeller, or one with more pitch than the
one included, may damage the electronics and battery packs.
Binding
Binding is the process of electronically linking the transmitter to the
receiver. The included transmitter and receiver are bound at the
factory. If rebinding is necessary, follow these steps:
NOTICE: Always keep all body parts, loose clothing and other items
away from the propellers.
IMPORTANT: If using an external receiver, follow the binding
instructions included with that receiver.
1. Ensure the vessel is secure in the included stand.
2. Insert the bind plug into the bind port on the receiver.
3. Power on the boat.
4. Power on the SLT3 transmitter to bind it to the boat.
5. Remove the bind plug before operation.
Maintenance
Propeller Service
1. Use an 8mm nut driver to loosen the nut (A) from the driveshaft (B).
2. Remove the nut and propeller (C) from the driveshaft.
3. Inspect the propeller for any damage or wear and replace as
necessary.
4. Assemble in reverse order. Correctly align the propeller with the
drive dog on the driveshaft.
8
1
2
3
Recoil 2
26-Inch Self-Righting Deep-V Brushless, RTR
®
C C
B
B
A A
Advertisement
Table of Contents
