Table of Contents
Advertisement
Installing the Transmitter Batteries
This transmitter requires 4 AA batteries (included).
1. Remove the battery cover from the transmitter.
2. Install the batteries as shown.
3. Install the battery cover.
CAUTION: NEVER remove the transmitter batteries while the
model is powered on. Loss of model control, damage, or injury
may occur.
CAUTION: If using rechargeable batteries, charge only
rechargeable batteries. Charging non-rechargeable batteries
may cause the batteries to burst, resulting in injury to persons and/
or damage to property.
CAUTION: Risk of explosion if battery is replaced by an
incorrect type. Dispose of used batteries according to national
regulations.
Transmitter Functions
SPECIFICATIONS
Power Supply: 4 AA Batteries
Operating Frequency: 2.4GHz
Transmit Power: <100mw
Control Protocol: SLT
Control: Proportional Steering and Throttle/Brake with Trim Knobs
Auxiliary Functions: 3 Position Throttle Limit Switch, Steering Rate
Knob to Change Steering Travel On-the-Fly, Programmable Servo
Travel for Steering and Throttle/Brake
A. Throttle Trim
Adjusts the throttle neutral point
B. Steering Trim
Adjusts the steering center point. Normally, the steering trim is
adjusted until the vehicle tracks straight.
C. LED
• Solid red lights: Indicates the power is ON and adequate battery
power
• Flashing red lights: Indicates the battery voltage is critically low.
Replace batteries
D. Steering Wheel
E. Throttle/Brake
F. Steering Rate
On-The-Fly knob for travel adjustment on the steering
G. Rocker Switch
• A: Self -Righting: Hold down to self right. Release when the boat
is upright.
• B: Not used
H. Throttle Limit
Limits throttle output to 50/75/100%
Select 50% or 75% for less experienced drivers or when you are
driving the vehicle in a small area.
I. Throttle (TH) Servo Reversing
Move the switch to reverse the throttle channel
J. Steering (ST) Servo Reversing
Move the switch to reverse the steering channel
K. Power Button
EN
4
A
B
C
D
E
F
G
H
I
J
K
5
Advertisement
Table of Contents
