Hazard Warning Flasher Switch; Ignition And Steering Lock; Locking The Steering - KTM 890 ADVENTURE R 2023 Manual

6 CONTROLS
6.5.2
6.6
6.7
Note
Danger of damage The parked vehicle can roll away or fall over.
–
Park the vehicle on a firm and level surface.
24

Hazard warning flasher switch

I00280-10

Ignition and steering lock

F01889-01

Locking the steering

400732-01
The hazard warning flasher switch
the switch.
The hazard warning flasher is used to indicate emergency situa-
tions.
Info
The hazard warning flasher can be activated or deactivated
while the ignition is switched on or up to 60 seconds after
the ignition is switched off.
Only keep the hazard warning flasher activated as long as
necessary as it depletes the 12-V battery.
Possible states
• The hazard warning flasher switch
• The hazard warning flasher switch
signals and the indicator lamp for the hazard warning flasher
in the combination instrument flash.
The ignition and steering lock is located in front of the upper triple
clamp.
Possible states
Ignition off – In this position, the ignition circuit
is interrupted, a running engine stops, and a
non-running engine will not start. The ignition key can
be removed.
Ignition on – In this position, the ignition circuit is
closed and the engine can be started.
Steering locked – In this position, the ignition circuit
is interrupted and the steering locked. The ignition
key can be removed.
–
Park the vehicle.
–
Turn the handlebar all the way to the left.
–
Insert the ignition key into the ignition and steering lock, press
in, and turn to the left. Remove the ignition key.
Steering is no longer possible.
1
is fitted on the right side of
is in the basic position
is pressed – All four turn