Table of Contents
Advertisement
8 ERGONOMICS
8.1
8.2
68
Handlebar position
F01906-10
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
F01907-10
On the upper triple clamp, there are three holes at a distance
A
of
to each other.
The holes on the handlebar support are placed at a distance of
from the center.
15 mm (0.59 in)
A
Hole distance
3.5 mm (0.138 in)
B
Hole distance
The handlebar can be mounted in six different positions. This
allows the handlebar to be mounted in the most comfortable posi-
tion for the rider.
–
1
Remove screws
. Take off the handlebar clamps
tion the handlebar so that screws
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
3
Remove screws
. Take off handlebar supports
–
Move the handlebar supports into the desired position
C
or
. Mount and tighten screws
Guideline
Mount the left and right handlebar supports in the same
position.
Screw, handle-
M10
bar support
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position handlebar clamp. Mount screws
evenly.
Guideline
Screw, handlebar
clamp
2
3
are accessible.
4
.
3
.
45 Nm (33.2 lbf ft)
Loctite
1
and tighten
M8
20 Nm (14.8 lbf ft)
B
. Posi-
B
A
,
®
243™
Advertisement
Table of Contents
