Advertisement
Troubleshooting & Operating Tips
DATA IS NOT BEING
TRANSFERRED
Do this:
Do this:
Do this:
Do this:
NAV DOES NOT WORK
Do this:
Try this:
8-8
Baud rate on the receiver and PC do not
match.
Use SETUP 7 to set the baud rate.
The PC or data logger is not turned on; the
PC was not ready to receive or transmit
data.
Turn the PC or data logger on. If using
a PC, you must also enter the Post-
Processing Software to select the LOG
submenu (or use the LOG software
module to log data in real time).
Cables and adapters are not secure or are
not connected correctly.
Check all cables and adapters; refer to
the illustration on page 4-9 for proper
connections.
The unit is not in continuous operation.
Turn the unit off, connect it to an
external power source, then turn the
unit back on; or use SETUP to turn the
Battery Saver off.
NAV displays bearing and distance informa-
tion only when a route has been activated.
Without an active route, only velocity-
related information is available.
Activate a route to navigate on.
You must be travelling faster than 0.3 km/
hr to get velocity-related data, such as
speed over ground (SOG), course over
ground (COG), steering, speed of advance
(SOA) or time to go (TTG).
Increase speed to 0.3 km/hr or greater.
ProMARK X
Advertisement
Chapters
