Table of Contents
Advertisement
QUICK SETUP GUIDE
LGX
PRO and LGX
®
CONNECTION
Do not connect a LGX
PRO stepper motor to a printer's cable without checking the wires and pins of the connection cable.
®
Not all printers are ready for a direct connection with the LGX
Before connecting a LGX
PRO Pro to any 3D printer check if the
®
connector pins are wired as shown below:
LEVER POSITIONS
Position 0
Position 1
Load or unload filament
For rigid materials.
without pressure from
the drive gears.
bondtech.se
PRO 2.85 Extruders
®
®
Position 2
For semi-flexible
materials
Shore hardness of ~95A
or when you need more
grip on rigid materials.
PRO. Some use stepper drivers with no protection and this may damage them.
After start of service, if the LGX
swap the top (or bottom) pair of wires to make a correction:
Position 3
For flexible materials
Shore hardness between
85 and 95A.
PRO is turning in the wrong direction,
®
Position 4
Position 5
For soft materials
For very soft materials
Shore hardness between
Shore hardness between
75 and 85A.
60 and 75A.
Reliability and Performance
Page 3
Advertisement
Table of Contents
Need help?
Do you have a question about the LGX PRO and is the answer not in the manual?
Questions and answers