Subscribe to Our Youtube Channel
Related Manuals for Bondtech DDG V2
Summary of Contents for Bondtech DDG V2
- Page 1 HOW TO Install DDG V2 on Ultimaker S3, S5 and S7 Difficulty Medium Steps Time Required 15 to 20 min PRODUCT PAGE Sections...
- Page 2 Install DDG V2 on Ultimaker 2+ & 3 INSTRUCTIONS GUIDE This guide is designed to be a reference manual for how to do install DDG V2 on Ultimaker S3, S5 and S7. Follow the instructions below or, if you prefer to watch a https://youtu.be/3djZu1M0Lng...
- Page 3 HOW TO Install DDG V2 on Ultimaker 2+ & 3 Open the extruder and remove the flow control Remove the flow control feeder. Discard the two extruder housing parts and the bowden coupler together with their content. spring. With a 2mm hex key, loosen the four screws Separate the two parts of the extruder.
- Page 4 HOW TO Install DDG V2 on Ultimaker 2+ & 3 HOW TO GET HELP We are available to help you with any questions or issues you may have. Simply go to our website where you can access our customer support and send us your questions or follow the provided link: https://www.bondtech.se/contact/#tab_technical-support-requests...
- Page 6 HOW TO Install DDG V2 on Ultimaker 2+ & 3 Add the flow control spring and close the lever Align the flow control board with the mounting Put the two halves together while pushing the flow hole, add and tighten the screw carefully.
Need help?
Do you have a question about the DDG V2 and is the answer not in the manual?
Questions and answers