Bondtech LGX Large Gears eXtruder Quick Start Manual

Download this manual

QUICK START GUIDE

Large Gears eXtruder®

Table of Contents

Need help?

Do you have a question about the LGX Large Gears eXtruder and is the answer not in the manual?

Page 1 QUICK START GUIDE Large Gears eXtruder®...
Page 2 1x Direct Drive Interface Plug (for Slice Engineering hotends) • 1x 2mm Hex Key (recommended tool) • 1x Product Line Information Brochure • 1x Powered By Bondtech sticker • 3x M3x30 mm Low Head screws • 4x M3x18 mm Stud with 5mm Hex with M3x4 thread •...
Page 3 Shore hardness Shore hardness Shore hardness the drivegears. between 60 and 75A. Shore hardness of ~95A between 85 and 95A. between 75 and 85A. or when you need more grip on rigid materials. Page 3/7 www.bondtech.se...
Page 4: Mounting Holes
LGX® to a toolhead, while the forward bottom mounting holes are intended to interface with Slice Engineering hotends. In addition to this the LGX® ships with four mountable studs for back mounting points at the motor. Page 4/7 www.bondtech.se...
Page 5: Machine Configuration
If these settings still gives you stringing, we suggest you dry your ﬁlament and calibrate your extrusion multiplier since that is often the root cause of stringing when retraction has these settings. Tuning the VREF, an example Page 5/7 www.bondtech.se...
Page 6: How To Get Help
We are available to help you with any questions or issues you may have. Simply go to our website where you can access our customer support and send us your questions or follow the provided link: https://www.bondtech.se/contact/#tab_technical-support-requests Page 6/7 www.bondtech.se...