Installation
14
3.4
Installation instructions
3.4.1
Mounting CLD 132 separate version
Wall mounting
For wall mounting, attach the mounting plate to the wall by drilling holes as required.
Anchors and screws are to be provided by the operator.
}°Ê££Ê UbÊÕÌ}ÊvÊ)Ê£ÎÓÊÃi«bÀbÌiÊÛiÀÃ
Post mounting
A mounting kit for installing the housing on horizontal or vertical posts or pipes
(max. Ø 60 mm / Ø 2.36") is available as an accessory (see chapter "Accessories").
}°Ê£ÓÊ 1ÕÌ}ÊÌÊvÀÊÃÌb}ÊÌ
iÊ)Ê£ÎÓÊÃi«bÀbÌiÊÛiÀÃÊÊ«ÃÌÃ
1.
Remove the mounting plate.
2.
Insert the holding bars through the pre-drilled holes of the mounting plate and
screw the mounting plate onto the transmitter.
3.
Use the brackets to install the SmarTec S on the post or pipe (Fig. 13).
SmarTec S CLD 132
∅ 7 / 0.28
225 / 8.86
mm / inch
C07-CLD132-11-06-00-en-007.eps
C07-CLD132xx-00-06-06-001.eps
Endress+Hauser