Safety Instructions; Designated Use; Installation, Commissioning And Operation; Operational Safety - Endress+Hauser SmarTec S CLD 132 Operating Instructions Manual

Safety instructions

4
1 Safety instructions
1.1

Designated use

The SmarTec S transmitter is a field-tested and reliable measuring transmitter used to
determine the conductivity of liquid media.
The SmarTec S is particularly suitable for use in the foodstuffs industry.
Any other use than the one described here compromises the safety of persons and the
entire measuring system and is, therefore, not permitted.
The manufacturer is not liable for damage caused by improper or non-designated use.
1.2

Installation, commissioning and operation

Please note the following items:
• Installation, electrical connection, commissioning, operation and maintenance of the
measuring system must only be carried out by trained technical personnel.
The technical personnel must be authorised for the specified activities by the system
operator.
• Technical personnel must have read and understood these Operating Instructions
and must adhere to them.
• Before commissioning the entire measuring point, check all the connections for
correctness. Ensure that electrical cables and hose connections are not damaged.
• Do not operate damaged products and secure them against unintentional
commissioning. Mark the damaged product as being defective.
• Measuring point faults may only be rectified by authorised and specially trained
personnel.
• If faults can not be rectified, the products must be taken out of service and secured
against unintentional commissioning.
• Repairs not described in these Operating Instructions may only be carried out at the
manufacturer's or by the Endress+Hauser service organisation.
1.3

Operational safety

The transmitter has been designed and tested according to the state of the art and left
the factory in perfect functioning order.
Relevant regulations and European standards have been met.
As the user, you are responsible for complying with the following safety conditions:
• Installation instructions
• Local prevailing standards and regulations.
Immunity to interference
This instrument has been tested for electromagnetic compatibility in industrial use
according to applicable European standards. It is protected against electromagnetic
interference by the following design measures:
• cable screening
• interference suppression filter
• interference suppression capacitors.
Protection against interference as specified above is valid only for an instrument
connected according to the instructions in these Operating Instructions.
SmarTec S CLD 132
Endress+Hauser