Table of Contents
Advertisement
SUMMER STORAGE / NON
USAGE
Please ensure that your stove is left clean and
moving components are well lubricated for the
summer months (during periods of prolonged non
use). If possible store the throat plate outside of
the stove, check all moveable components, at
regular intervals, to ensure they are moving freely.
Allow air movement through the stove, by opening
the air wash control to about half way open or
leave the door ajar. This will allow a free flow of air
through the appliance thus preventing moisture
and condensation
forming inside the stove and chimney. This
preventative maintenance will ensure your stove
stays in the best condition for the coming winter
months.
ADJUSTING THE DOOR HINGES
Once the appliance has been under fire for a
period of time the fire door may appear to have
moved out of alignment in relation to the door
aperture or catch. This is quite normal and due to
the settling of the casting.
The fire door can be re-aligned as follows :
When the appliance is cold, open the fire
door so that it is at right angles to the front of
the stove.
Lift the fire door up off its hinges.
Gently tap the hinge pins in the direction to
compensate for the misalignment. (Fig. 6)
Re-fit the door and check to ensure it now
sits square to the body; if not repeat the
above steps.
If the fire door needs to be raised, please follow :
When the appliance is cold, open the fire
door so that it is at right angles to the front of
the stove.
Lift the fire door up off the hinges.
Drop one washer 6.35mm ID x 14mm OD
on the top and bottom hinge pins.
Aarrow Ecoburn Inset 5
SERVICE & MAINTENANCE
Refit the door and check.
Please Note : There is no adjustment to the
door lock / catch assembly. However,
periodically check the tightness of the
retaining screw to the end of the door handle
shaft. ( Fig. 7 )
Fig. 6. Adjusting The Door Hinges
Fig. 7. Retaining Screw Tightness
FUEL RETAINER INSPECTION
A fuel retainer is supplied with the stove.
Periodically check for any bowing to the
fuel retainer and replace as necessary.
Please Note :
This operation should only be carried out when
the appliance is unlit and cold.
Tighten
Screw
Page 17
Advertisement
Table of Contents
