Table of Contents
Advertisement
Figure 163. Removing a 0U PDU
Install or remove a 1U device into or from the rack side
See this topic to learn how to install or remove a 1U device into or from the rack side.
About this task
S001
DANGER
Electrical current from power, telephone, and communication cables is hazardous.
To avoid a shock hazard:
• Connect all power cords to a properly wired and grounded electrical outlet/source.
• Connect any equipment that will be attached to this product to properly wired outlets/sources.
• When possible, use one hand only to connect or disconnect signal cables.
• Never turn on any equipment when there is evidence of fire, water, or structural damage.
• The device might have more than one power cord, to remove all electrical current from the
device, ensure that all power cords are disconnected from the power source.
S013
.
Chapter 5
Hardware removal, installation and conversion
143
Advertisement
Table of Contents
