Table of Contents
Advertisement
Figure 43. Removing a side cover
Unlock the side cover with the key.
Press on the two latches on both sides of the cover to disengage it from the rack.
Rotate the top of the side cover away from the rack, and remove it.
Step 6.
If there are plans of installing devices in any side pocket of the cabinets, do it now and complete all
the required cable connection and setup (see
Make sure to complete all the required cable connection and device setup before installing baying
kits to the cabinets, as these tasks will be hard to operate afterwards.
Step 7.
Install four cage nuts on upper and lower locations on the side of adjacent cabinets as preparation
for baying kit installation. Use the cage nuts that come with the baying kit.
38
ThinkSystem Heavy Duty Full Depth 48U Rack Cabinet User Guide
"Instal a 1U device into the side pocket" on page
82).
Advertisement
Table of Contents
