DR 10 HP CHIPPER Safety & Operating Instructions Manual page 33

NOTE: After you perform the adjustment, make sure that the Key remained in the Rotor Shaft and flush with
the end surface of the Shaft (Figure 11 on page 30).
®
c) Apply Loctite 243 to the threads of the Set Screws and reinsert them into the Drive Pulley Hub.
d) Tighten the Set Screws while maintaining the alignment of the Clutch and Rotor Pulley (Figure 11).
e) Recheck the alignment after tightening the Set Screws.
6. Reinstall the Belt Guard.
NOTE: Check and re-tighten the Drive Belt, if necessary, after an initial break-in period of one (1) hour.
Engine Bolts, Front
Belt Tensioner
Figure 9
Clutch Rotor Pulley
Belt
Straight Edge
Figure 10
CALL TOLL FREE 1-800-DR-OWNER
29