Page 1
K 2 Car Care Kit OPERATOR MANUAL High-Pressure Washer ..2 MANUEL D’UTILISATION Nettoyeur haute pression ..17 MANUAL DE USUARIO Limpiador de alta presión ..34...
HIGH-PRESSURE WASHER OPERATOR MANUAL Model Overview Owner/User Responsibility Important Safety Instructions The owner and/or user must have an un- Assembly Instructions derstanding of the manufacturer’s oper- ating instructions and warnings before Operating Instructions using this pressure washer. Using the Accessories Warning information should be empha- Working with Detergents sized and understood.
IMPORTANT SAFETY INSTRUCTIONS WARNING physical injuries to the operator and When using this product basic precau- irreversible damage to the machine. tions should always be followed, includ- WARNING – Risk of Electrocu- ing the following: tion Read all the instructions before using Inspect cord before using –...
Page 5
OPERATE THIS PUMP WITH COM- WATER SUPPLY PONENTS RATED LESS THAN 1600 (Cold Water Only) PSI WORKING PRESSURE (INCLUD- CAUTION ING BUT NOT LIMITED TO SPRAY When connecting the water inlet to the GUNS, HOSE AND HOSE CONNEC- water supply mains, local regulations of TIONS).
STEP 5: ASSEMBLY INSTRUCTIONS Pull out the locking slide of the trigger – gun handle. Assembly Insert the small end of the high-pres- – STEP 1: sure hose into place. Insert wheels into the body of the Push the locking slide back into the –...
Page 7
STEP 2: gfci_test.php for detailed instructions for your type of GFCI. Insert the spray wand of your choice WARNING into the trigger gun. Press in against Do not use if above test fails. the spring tension and twist into locked position.
USING THE ACCESSORIES Detergent Foamer WARNING Ideal for applications which require a To avoid serious injury never point spray thick foam. Simply fill the resevoir cup nozzle at yourself, other persons or ani- with liquid pressure washer detergent to mals. generate a foam spray.
STEP 2: WORKING WITH Fill a container with Kärcher deter- DETERGENTS gent. Place the filter end of detergent siphon tube into the container. For best results see Cleaning Tips for specific information on how to clean different surfaces. Always Use Kärcher ®...
WINTERIZING AND LONG- CARE AND MAINTENANCE TERM STORAGE INSTRUCTIONS 1 Disconnect all water connections. Cleaning the water inlet filter 2 Turn on the machine for a few sec- onds, until the water which had re- STEP 1: mained in the pump exits, turn off Disconect the connector from the immediately.
CLEANING TIPS House Siding CAUTION (with or without detergent). Pre-rinse Before cleaning any surface an in- cleaning surface with fresh water. If us- conspicuous area should be cleaned ing detergent, apply to surface at low to test spray pattern and distance for pressure (for best results, limit your maximum cleaning results.
gent to dry on surface. If needed, use OPTIONAL CLEANING special wash brush attachment (not in- ACCESSORIES cluded) to remove stubborn dirt. Rinse at high-pressure in a sweeping motion Optional accessories are available to keeping the spray nozzle approximately further enhance your cleaning capabili- 15-20 cm (6-8 in.) from the cleaning sur- ties.
Page 14
Rotating Wash Brush (bayonet) Wet Sandblasting Kit (bayonet) For more effortless cleaning of all Why spend hours stripping old paint and smooth surfaces (painted, glass and rust by hand using harsh chemicals? Let plastic) try the Kärcher ® Rotating Wash the Kärcher ®...
TROUBLESHOOTING WARNING Disconnect the unit from the power source before making any repair. Issue Cause Solution Motor will not start On/Off switch is in the “OFF” Turn switch to the “ON” (I) (0) position. position Power cord is not plugged in. Plug in power cord. Electrical outlet does not Try a different outlet.
Page 16
Issue Cause Solution No detergent. Detergent is too thick. Dilute detergent, for best results use Kärcher detergent. Filter on detergent siphon tube Run warm water through filter is clogged. to remove debris. Damaged or clogged detergent Remove obstruction or replace siphon tube.