Command Examples; Virtual Uart - Silicon Laboratories SLWSTK6242A User Manual

UG192: EZR32HG 915 MHz 20 dBm Wireless Starter Kit User's Guide
Board Controller

6.1.3 Command Examples

PTI Configuration
pti config 0 efruart 1600000
Configures PTI to use the "EFRUART" mode at 1.6 Mb/s.
Serial Port Configuration
serial config vcom handshake enable
Enables hardware handshake on the VCOM UART connection.

6.2 Virtual UART

The Virtual UART interface provides a high performance application data interface that does not require any additional I/O pins apart
from the debug interface. It is based on SEGGER's Real Time Transfer (RTT) technology, and uses Serial Wire Output (SWO) to get
appliaction data from the device, and a shared memory interface to send data to the target application.
The Wireless Starter Kit makes the Virtual UART interface available on TCP/IP port 4900.
silabs.com | Building a more connected world. Rev. 1.01 | 23