Table of Contents
Advertisement
Terminal Emulation
B
Console Port
To Connect to the CLI
1. Connect the device's
console port
console
cable.
2. Start a
terminal emulation program
COM port, and use the following settings:
Baud Rate:
9600
Data bits:
8
Parity:
None
Stop bits:
1
Flow Control:
None
3. Press
Enter
on your keyboard to
connect to the
4. Login using username
"admin"
and no password. You can now proceed with
configuring your device.
8
Serial Port
to the management computer using the provided
on the management computer, select the
CLI.
Installation
3
The FortiManager unit can be mounted in any standard
provided mounting hardware.
Please also read "Cautions and Warnings" on page 18 prior to installing your device.
Caution:
The rack must be
stabilized
before sliding the unit out for servicing.
Failure to stabilize may cause the rack to tip over.
Do not pick up the device with the front handles. They are designed to pull the
system from a rack only.
Electrostatic discharge (ESD) can damage your Fortinet equipment.
To avoid
personal injury
or damage to the unit, it is recommended that
people install the unit into the rack.
Do not place
heavy objects
on the unit.
Rack Precautions
•
Ensure the
leveling jacks
on the bottom of the rack are
with the full weight of the rack resting on the jacks.
•
For single rack installation,
stabilizers
•
For multiple rack installations, the racks should be
•
Ensure the rack is
stable
before extending a component from the rack.
•
Only extend
one component
at a time; extending
cause the rack to become unstable.
Note:
After installing the device into the rack, install the hard disk drives into the
device.
19 inch rack
unit with the
two or more
fully extended
to the floor
should be attached to the rack.
coupled
together.
two or more
simultaneously may
9
Advertisement
Table of Contents
